Language:
| Turbo Model | TD03 |
| Vehicle OE No | 756301503 |
| Model | 335i 3.0LP 302HP 06- |
| Engine | N54(Cyl 1-3) |
| ETP # | OE # | Ref # | |
| CHRA | 49131-08911 | ||
| Bearing Housing | NA | ||
| Shaft & Wheel | NA | ||
| Compressor Wheel | NA | ||
| Back Plate | NA | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | NA | ||
| Compressor Cover | NA | ||
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -95,000rpm | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | P1-16.8+/-1kPa 1mm/P2-12+/-2kPa 4mm | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 49131-07030 |
| Bearing Housing OE | NA |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 49131-07030 |
| Shaft & Wheel OE | NA |
| Ref | |
| Inducer Diameter(I) | 39.8 |
| Exducer Diameter(II) | 35.1 |
| Tip Height(III) | 6.5 |
| Journal Bearing Diameter(IV) | 6 |
| Comp Wheel Bore(V) | 4 |
| Number of Blades | 11 |
| Type Of Shaft | Straight |
| ETP No. | |
| Turbo OE | 49131-07030 |
| Compressor Wheel OE | NA |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 49131-07030 |
| Seal Plate & Back Plate OE | NA |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | 39.9 |
| Plate Depth(IV) | 10 |
| Plate Diameter(V) | 8 |
| Flatback / Superback | - |
