Language:
| Turbo Model | GT2260V |
| Vehicle OE No | 7790308L |
| Model | 730 D -6 cyl. -3.0L |
| Engine | M57 TU E65 REA |
| ETP # | OE # | Ref # | |
| CHRA | 660197 in stock | NA | |
| Bearing Housing | 110144 in stock | NA | |
| Shaft & Wheel | 260141 in stock | NA | |
| Compressor Wheel | 280258 in stock | NA | |
| Back Plate | 360136 in stock | NA | |
| Heat Shield | 350108 in stock | NA | |
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | NA | ||
| Compressor Cover | NA | ||
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 0.8G Max 0 -60,000rpm / 1.2G Max 60,000 -108,000 | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | 110144 |
| Turbo OE | 742730-0001 |
| Bearing Housing OE | NA |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | 260141 |
| Turbo OE | 742730-0001 |
| Shaft & Wheel OE | NA |
| Ref | |
| Inducer Diameter(I) | 50 |
| Exducer Diameter(II) | 46 |
| Tip Height(III) | 9.4 |
| Journal Bearing Diameter(IV) | 7.9 |
| Comp Wheel Bore(V) | 5.1 |
| Number of Blades | 9 |
| Type Of Shaft | Slender |
| ETP No. | 280258 |
| Turbo OE | 742730-0001 |
| Compressor Wheel OE | NA |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | 360136 |
| Turbo OE | 742730-0001 |
| Seal Plate & Back Plate OE | NA |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
