Language:
| Turbo Model | GT1549S |
| Vehicle OE No | 9624858780 |
| Model | Xantia 110HP (97-98) 2.1L D |
| Engine | XUD11BTE/P8C |
| ETP # | OE # | Ref # | |
| CHRA | 660330 in stock | NA | |
| Bearing Housing | 110110 in stock | NA | |
| Shaft & Wheel | 260111 in stock | NA | |
| Compressor Wheel | 280220 in stock | NA | |
| Back Plate | 360112 in stock | NA | |
| Heat Shield | 350104 in stock | NA | |
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | NA | ||
| Compressor Cover | NA | ||
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 0.8G Max 0 -90,000rpm / 2.0G Max 90,000 -138,000 | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | 110110 |
| Turbo OE | 454155-0001 |
| Bearing Housing OE | NA |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | 260111 |
| Turbo OE | 454155-0001 |
| Shaft & Wheel OE | NA |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | 280220 |
| Turbo OE | 454155-0001 |
| Compressor Wheel OE | NA |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | 360112 |
| Turbo OE | 454155-0001 |
| Seal Plate & Back Plate OE | NA |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
