Language:
| Turbo Model | K04-2070EAB7.88GCASD |
| Vehicle OE No | 37590 |
| Model | ZX, Xantia |
| Engine | XUD9ASD |
| ETP # | OE # | Ref # | |
| CHRA | 5304-710-0502 | ||
| Bearing Housing | 5304-150-0004 | ||
| Shaft & Wheel | 5304-120-5009 | ||
| Compressor Wheel | 5304-123-2008 | ||
| Back Plate | 5304-151-5702 | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 5304-100-9013 | ||
| Compressor Cover | 5304-101-5005 | ||
| Actuator | 5820-110-4039 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.0G Max 0 -85,000rpm / 1.5G Max 85,000 -135,000 | ||
| T/hsg Angle | 120 | ||
| C/hsg Angle | 265 | ||
| Actuator Calibration 1 | Pressure 0.45 Bar = 1.15mm Rod Lift | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 5304-970-0011 |
| Bearing Housing OE | 5304-150-0004 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 5304-970-0011 |
| Shaft & Wheel OE | 5304-120-5009 |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 5304-970-0011 |
| Compressor Wheel OE | 5304-123-2008 |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 5304-970-0011 |
| Seal Plate & Back Plate OE | 5304-151-5702 |
| Ref | |
| Plate Diameter(III) | 51.20 |
| Plate Diameter(II) | 76 |
| Plate Diameter(I) | 112.9 |
| Plate Depth(IV) | 16.75 |
| Plate Diameter(V) | 10 |
| Flatback / Superback | Superback |
