Language:
| Turbo Model | K16-2267GGB5.82GAAXD |
| Vehicle OE No | 37588 |
| Model | Jumper |
| Engine | DJ5TED |
| ETP # | OE # | Ref # | |
| CHRA | 5316-711-0524 | ||
| Bearing Housing | 5316-150-0032 | ||
| Shaft & Wheel | 5316-120-5004 | ||
| Compressor Wheel | 5316-123-2003 | ||
| Back Plate | 5316-151-5701 | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 5316-100-9018 | ||
| Compressor Cover | 5316-101-5019 | ||
| Actuator | 5820-110-4035 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -85,000rpm | ||
| T/hsg Angle | 241.5 | ||
| C/hsg Angle | 273.5 | ||
| Actuator Calibration 1 | Pressure 1.35 Bar = 2.85mm Rod Lift | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 5316-970-6737 |
| Bearing Housing OE | 5316-150-0032 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 5316-970-6737 |
| Shaft & Wheel OE | 5316-120-5004 |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 5316-970-6737 |
| Compressor Wheel OE | 5316-123-2003 |
| Ref | |
| Inducer Diameter(III) | 36.7 |
| Exducer Diameter(IV) | 54.8 |
| Tip Height(II) | 4.5 |
| Total Height(I) | 25.8 |
| Number of Blades | 6 |
| Flatback / Superback(Trim) | 2267GGB |
| Shaft / Bore | 5.4 |
| ETP No. | |
| Turbo OE | 5316-970-6737 |
| Seal Plate & Back Plate OE | 5316-151-5701 |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
