Language:
| Turbo Model | GT1752V |
| Vehicle OE No | 18900-RBD-E010-M2 |
| Model | Accord -4 cyl. -2.2L -DI D |
| Engine | RBD |
| ETP # | OE # | Ref # | |
| CHRA | NA | ||
| Bearing Housing | NA | ||
| Shaft & Wheel | NA | ||
| Compressor Wheel | 717697-0004 | ||
| Back Plate | NA | ||
| Heat Shield | 433112-0001 | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 701865-0028 | ||
| Compressor Cover | 737195-0004 | ||
| Actuator | 721777-0006 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | - | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 729125-0007 |
| Bearing Housing OE | NA |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 729125-0007 |
| Shaft & Wheel OE | NA |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 729125-0007 |
| Compressor Wheel OE | 717697-0004 |
| Ref | |
| Inducer Diameter(III) | 38.6 |
| Exducer Diameter(IV) | 52 |
| Tip Height(II) | 4.1 |
| Total Height(I) | 27 |
| Number of Blades | 5 |
| Flatback / Superback(Trim) | Deep Superback |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 729125-0007 |
| Seal Plate & Back Plate OE | NA |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
