Language:
| Turbo Model | TF035HM-10T |
| Vehicle OE No | 28200-4A150 |
| Model | H 200 / Starex / Libero / Galloper |
| Engine | D4BH 4D56(A1) 2.5 |
| ETP # | OE # | Ref # | |
| CHRA | NA | ||
| Bearing Housing | 49377-25100 | ||
| Shaft & Wheel | 49135-30100 | ||
| Compressor Wheel | TF035-10T | ||
| Back Plate | 49135-15405 | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 49135-17700 | ||
| Compressor Cover | NA | ||
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | - | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 49135-04000 |
| Bearing Housing OE | 49377-25100 |
| Ref | |
| VNT or Non-VNT | NON |
| Oil or Water Cooled | WATER |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | 70 |
| ETP No. | |
| Turbo OE | 49135-04000 |
| Shaft & Wheel OE | 49135-30100 |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 49135-04000 |
| Compressor Wheel OE | TF035-10T |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 49135-04000 |
| Seal Plate & Back Plate OE | 49135-15405 |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | 39.9 |
| Plate Depth(IV) | 10 |
| Plate Diameter(V) | 10 |
| Flatback / Superback | Superback |
