Language:
| Turbo Model | TD025-03C-2.8 |
| Vehicle OE No | 9610-055 |
| Model | Focs |
| Engine | FOCS(POWER) |
| ETP # | OE # | Ref # | |
| CHRA | 49173-09530 | ||
| Bearing Housing | 49173-25100 | ||
| Shaft & Wheel | 49173-30200 | ||
| Compressor Wheel | 49173-41410 | ||
| Back Plate | NA | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 49173-11300 | ||
| Compressor Cover | NA | ||
| Actuator | 49173-18810 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -95,000rpm | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 49173-07301 |
| Bearing Housing OE | 49173-25100 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 49173-07301 |
| Shaft & Wheel OE | 49173-30200 |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 49173-07301 |
| Compressor Wheel OE | 49173-41410 |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 49173-07301 |
| Seal Plate & Back Plate OE | NA |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | 39.9 |
| Plate Depth(IV) | 10 |
| Plate Diameter(V) | 7.9 |
| Flatback / Superback | SUPERBACK |
