Language:
| Turbo Model | GT2259 |
| Vehicle OE No | 9040960799 |
| Model | Bus/Truck 712 Atego |
| Engine | OM904LA |
| ETP # | OE # | Ref # | |
| CHRA | 451298-0009 | ||
| Bearing Housing | 435793-0002 | ||
| Shaft & Wheel | 434707-0001 | ||
| Compressor Wheel | 451295-0007 | ||
| Back Plate | 434679-0001 | ||
| Heat Shield | 434302-0001 | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 451503-0001 | ||
| Compressor Cover | 451522-0003 | ||
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.0G Max 0 -90,000rpm | ||
| T/hsg Angle | 180 | ||
| C/hsg Angle | 263.5 | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 452214-0003 |
| Bearing Housing OE | 435793-0002 |
| Ref | |
| VNT or Non-VNT | NON |
| Oil or Water Cooled | OIL |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | 68 |
| ETP No. | |
| Turbo OE | 452214-0003 |
| Shaft & Wheel OE | 434707-0001 |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 452214-0003 |
| Compressor Wheel OE | 451295-0007 |
| Ref | |
| Inducer Diameter(III) | 42.8 |
| Exducer Diameter(IV) | 59 |
| Tip Height(II) | 4.5 |
| Total Height(I) | - |
| Number of Blades | 8 |
| Flatback / Superback(Trim) | 53 |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 452214-0003 |
| Seal Plate & Back Plate OE | 434679-0001 |
| Ref | |
| Plate Diameter(III) | 61.30 |
| Plate Diameter(II) | 112.7 |
| Plate Diameter(I) | 121.5 |
| Plate Depth(IV) | - |
| Plate Diameter(V) | 9.3 |
| Flatback / Superback | - |
