Language:
| Turbo Model | T2 |
| Vehicle OE No | 6050960599 |
| Model | E250 |
| Engine | OM605 |
| ETP # | OE # | Ref # | |
| CHRA | 443854-0204 | ||
| Bearing Housing | NA | ||
| Shaft & Wheel | NA | ||
| Compressor Wheel | 447449-0010 | ||
| Back Plate | NA | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 434575-0001 | ||
| Compressor Cover | 434546-0009 | ||
| Actuator | 434694-0002 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -85,000rpm | ||
| T/hsg Angle | 265 | ||
| C/hsg Angle | 153 | ||
| Actuator Calibration 1 | 0 bar = 0 mm | ||
| Actuator Calibration 2 | 0.120 = 1.00 -4.00 | ||
| Actuator Calibration 3 | 0.500 = Vanes Closed | ||
| ETP No. | |
| Turbo OE | 454156-0001 |
| Bearing Housing OE | NA |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 454156-0001 |
| Shaft & Wheel OE | NA |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 454156-0001 |
| Compressor Wheel OE | 447449-0010 |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 454156-0001 |
| Seal Plate & Back Plate OE | NA |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
