Language:
| Turbo Model | K16-2471OYCKB5.82GAAWD |
| Vehicle OE No | 9040967299 |
| Model | Atego/Unimog/Bus |
| Engine | OM904LA-E3 |
| ETP # | OE # | Ref # | |
| CHRA | 5316-710-0016 | ||
| Bearing Housing | 5316-150-0066 | ||
| Shaft & Wheel | 5316-120-5015 | ||
| Compressor Wheel | 5324-123-2039 | ||
| Back Plate | 5324-151-5714 | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 5316-100-9026 | ||
| Compressor Cover | 5324-101-3001 | ||
| Actuator | 5820-110-4181 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -85,000rpm | ||
| T/hsg Angle | 180 | ||
| C/hsg Angle | 286 | ||
| Actuator Calibration 1 | Pressure 2.19 Bar = 4.0mm Rod Lift | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 5316-970-7118 |
| Bearing Housing OE | 5316-150-0066 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 5316-970-7118 |
| Shaft & Wheel OE | 5316-120-5015 |
| Ref | |
| Inducer Diameter(I) | 55 |
| Exducer Diameter(II) | 46.2 |
| Tip Height(III) | 6.5 |
| Journal Bearing Diameter(IV) | 8.5 |
| Comp Wheel Bore(V) | 5.4 |
| Number of Blades | 12 |
| Type Of Shaft | Straight |
| ETP No. | |
| Turbo OE | 5316-970-7118 |
| Compressor Wheel OE | 5324-123-2039 |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 5316-970-7118 |
| Seal Plate & Back Plate OE | 5324-151-5714 |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
