Language:
| Turbo Model | GT1856V |
| Vehicle OE No | A6470960099 |
| Model | E Class (New) W211. |
| Engine | OM647 |
| ETP # | OE # | Ref # | |
| CHRA | 703891-0066 | ||
| Bearing Housing | 722282-0050 | ||
| Shaft & Wheel | 434882-0010 | ||
| Compressor Wheel | 436563-0009 | ||
| Back Plate | 703682-0043 | ||
| Heat Shield | 443768-0003 | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 711008-0002 | ||
| Compressor Cover | 727462-0001 | ||
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 0.65G Max 0 -90,000rpm / 2.00G Max 90,000 -168,0 | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 727463-0001 |
| Bearing Housing OE | 722282-0050 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 727463-0001 |
| Shaft & Wheel OE | 434882-0010 |
| Ref | |
| Inducer Diameter(I) | 50 |
| Exducer Diameter(II) | 42.7 |
| Tip Height(III) | 8.2 |
| Journal Bearing Diameter(IV) | 7.9 |
| Comp Wheel Bore(V) | 5.1 |
| Number of Blades | 9 |
| Type Of Shaft | Straight |
| ETP No. | |
| Turbo OE | 727463-0001 |
| Compressor Wheel OE | 436563-0009 |
| Ref | |
| Inducer Diameter(III) | 41.6 |
| Exducer Diameter(IV) | 56 |
| Tip Height(II) | 4.6 |
| Total Height(I) | 30.8 |
| Number of Blades | 6 |
| Flatback / Superback(Trim) | Deep Superback |
| Shaft / Bore | 5.1 |
| ETP No. | |
| Turbo OE | 727463-0001 |
| Seal Plate & Back Plate OE | 703682-0043 |
| Ref | |
| Plate Diameter(III) | 57.50 |
| Plate Diameter(II) | 100.2 |
| Plate Diameter(I) | 129.1 |
| Plate Depth(IV) | 13.7 |
| Plate Diameter(V) | 10 |
| Flatback / Superback | Superback |
