Language:
| Turbo Model | GT2256V |
| Vehicle OE No | A6470900280 |
| Model | Sprinter Van |
| Engine | OM647 |
| ETP # | OE # | Ref # | |
| CHRA | NA | ||
| Bearing Housing | NA | ||
| Shaft & Wheel | NA | ||
| Compressor Wheel | 702485-0011 | ||
| Back Plate | 434820-0003 | ||
| Heat Shield | 443768-0003 | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | NA | ||
| Compressor Cover | NA | ||
| Actuator | 721120 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | - | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 736088-0003 |
| Bearing Housing OE | NA |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 736088-0003 |
| Shaft & Wheel OE | NA |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 736088-0003 |
| Compressor Wheel OE | 702485-0011 |
| Ref | |
| Inducer Diameter(III) | 40.4 |
| Exducer Diameter(IV) | 56 |
| Tip Height(II) | 5.5 |
| Total Height(I) | 30.9 |
| Number of Blades | 6 |
| Flatback / Superback(Trim) | Superback |
| Shaft / Bore | 5.1 |
| ETP No. | |
| Turbo OE | 736088-0003 |
| Seal Plate & Back Plate OE | 434820-0003 |
| Ref | |
| Plate Diameter(III) | 57.50 |
| Plate Diameter(II) | 100.2 |
| Plate Diameter(I) | 129.1 |
| Plate Depth(IV) | 13.7 |
| Plate Diameter(V) | 10 |
| Flatback / Superback | Superback |
