Language:
| Turbo Model | TD04-10T |
| Vehicle OE No | MR204919 |
| Model | NA |
| Engine | 4D56 W I/C DOM |
| ETP # | OE # | Ref # | |
| CHRA | 49177-08260 | ||
| Bearing Housing | 49177-25800 | ||
| Shaft & Wheel | 49177-30120 | ||
| Compressor Wheel | 49177-44200 | ||
| Back Plate | NA | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 49377-15420 | ||
| Compressor Cover | 49377-57080 | ||
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | - | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 49177-02550 |
| Bearing Housing OE | 49177-25800 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 49177-02550 |
| Shaft & Wheel OE | 49177-30120 |
| Ref | |
| Inducer Diameter(I) | 47.1 |
| Exducer Diameter(II) | 40.0 |
| Tip Height(III) | 6.8 |
| Journal Bearing Diameter(IV) | 7.5 |
| Comp Wheel Bore(V) | 5.0 |
| Number of Blades | 12 |
| Type Of Shaft | TD04 |
| ETP No. | |
| Turbo OE | 49177-02550 |
| Compressor Wheel OE | 49177-44200 |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 49177-02550 |
| Seal Plate & Back Plate OE | NA |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
