Language:
| Turbo Model | TB2525 |
| Vehicle OE No | NA |
| Model | NA |
| Engine | NA |
| ETP # | OE # | Ref # | |
| CHRA | 431876-0021 | ||
| Bearing Housing | 432351-0003 | ||
| Shaft & Wheel | 431126-0001 | ||
| Compressor Wheel | 431350-0001 | ||
| Back Plate | 432280-0001 | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 430609-0113 | ||
| Compressor Cover | 409589-0085 | ||
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -85,000rpm | ||
| T/hsg Angle | 167 | ||
| C/hsg Angle | 183 | ||
| Actuator Calibration 1 | .79-.84 BAR = .38 MM | ||
| Actuator Calibration 2 | 1.27-1.3 BAR = 4.0 MM | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 465795-0001 |
| Bearing Housing OE | 432351-0003 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 465795-0001 |
| Shaft & Wheel OE | 431126-0001 |
| Ref | |
| Inducer Diameter(I) | 52.8 |
| Exducer Diameter(II) | 41.9 |
| Tip Height(III) | 6.3 |
| Journal Bearing Diameter(IV) | 9.2 |
| Comp Wheel Bore(V) | 6 |
| Number of Blades | 11 |
| Type Of Shaft | Straight |
| ETP No. | |
| Turbo OE | 465795-0001 |
| Compressor Wheel OE | 431350-0001 |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 465795-0001 |
| Seal Plate & Back Plate OE | 432280-0001 |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | 44.5 |
| Plate Depth(IV) | 6.7 |
| Plate Diameter(V) | 12.7 |
| Flatback / Superback | superback |
