Language:
| Turbo Model | GT1549S |
| Vehicle OE No | 144115M310 |
| Model | Almera 2.2i Di |
| Engine | YD1 (HS |
| ETP # | OE # | Ref # | |
| CHRA | 702246-0005 | ||
| Bearing Housing | 713632-0001 | ||
| Shaft & Wheel | 434713-0005 | ||
| Compressor Wheel | 436132-0003 | ||
| Back Plate | 700593-0004 | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 430609-0376 | ||
| Compressor Cover | 714089-0001 | ||
| Actuator | 433489-0035 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.0G Max 0 -138,000rpm | ||
| T/hsg Angle | 137 | ||
| C/hsg Angle | 240 | ||
| Actuator Calibration 1 | 1.15 -1.21 bar = 0.38 mm | ||
| Actuator Calibration 2 | 1.41 -1.50 bar = 4.00 mm | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 705306-0006 |
| Bearing Housing OE | 713632-0001 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 705306-0006 |
| Shaft & Wheel OE | 434713-0005 |
| Ref | |
| Inducer Diameter(I) | 41.5 |
| Exducer Diameter(II) | 35.2 |
| Tip Height(III) | 7.1 |
| Journal Bearing Diameter(IV) | 7.88 |
| Comp Wheel Bore(V) | 5.08 |
| Number of Blades | 9 |
| Type Of Shaft | Slender |
| ETP No. | |
| Turbo OE | 705306-0006 |
| Compressor Wheel OE | 436132-0003 |
| Ref | |
| Inducer Diameter(III) | 34.7 |
| Exducer Diameter(IV) | 49 |
| Tip Height(II) | 4.5 |
| Total Height(I) | 24.8 |
| Number of Blades | 6 |
| Flatback / Superback(Trim) | Superback |
| Shaft / Bore | 5.1 |
| ETP No. | |
| Turbo OE | 705306-0006 |
| Seal Plate & Back Plate OE | 700593-0004 |
| Ref | |
| Plate Diameter(III) | 50.1 |
| Plate Diameter(II) | 95.3 |
| Plate Diameter(I) | 120 |
| Plate Depth(IV) | 12 |
| Plate Diameter(V) | 9.3 |
| Flatback / Superback | Superback |
