Language:
| Turbo Model | GT2252S |
| Vehicle OE No | 1441169T60 |
| Model | L35 |
| Engine | BD30Ti |
| ETP # | OE # | Ref # | |
| CHRA | 451298-0014 | ||
| Bearing Housing | 433275-0002 | ||
| Shaft & Wheel | 434716-0005 | ||
| Compressor Wheel | 436322-0005 | ||
| Back Plate | 434689-0002 | ||
| Heat Shield | 434302-0001 | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 436313-0009 | ||
| Compressor Cover | 713468-0002 | ||
| Actuator | 432340-0087 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 0.8G Max 0 -60,000rpm / 1.2G Max 60,000 -108,000 | ||
| T/hsg Angle | 100 | ||
| C/hsg Angle | 340 | ||
| Actuator Calibration 1 | 1.000 -1.040 = 1.00 | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 709693-0001 |
| Bearing Housing OE | 433275-0002 |
| Ref | |
| VNT or Non-VNT | NON |
| Oil or Water Cooled | OIL |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | 68 |
| ETP No. | |
| Turbo OE | 709693-0001 |
| Shaft & Wheel OE | 434716-0005 |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 709693-0001 |
| Compressor Wheel OE | 436322-0005 |
| Ref | |
| Inducer Diameter(III) | 40.2 |
| Exducer Diameter(IV) | 52 |
| Tip Height(II) | 3.6 |
| Total Height(I) | - |
| Number of Blades | 6 |
| Flatback / Superback(Trim) | 60 |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 709693-0001 |
| Seal Plate & Back Plate OE | 434689-0002 |
| Ref | |
| Plate Diameter(III) | 53.00 |
| Plate Diameter(II) | 87.2 |
| Plate Diameter(I) | 107.5 |
| Plate Depth(IV) | 12 |
| Plate Diameter(V) | 10 |
| Flatback / Superback | Superback |
