Language:
| Turbo Model | GT25V |
| Vehicle OE No | 6025110523 |
| Model | Espace |
| Engine | J8S612 |
| ETP # | OE # | Ref # | |
| CHRA | 443893-0015 | ||
| Bearing Housing | 443652-0012 | ||
| Shaft & Wheel | 448941-0008 | ||
| Compressor Wheel | 431350-0017 | ||
| Back Plate | NA | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | 433071-0001 | ||
| Turbine Housing | 435871-0001 | ||
| Compressor Cover | 409589-0409 | ||
| Actuator | 432960-0008 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -85,000rpm | ||
| T/hsg Angle | 267.5 | ||
| C/hsg Angle | 34 | ||
| Actuator Calibration 1 | 0.430 -0.500 = 1.00 | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 454096-0001 |
| Bearing Housing OE | 443652-0012 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 454096-0001 |
| Shaft & Wheel OE | 448941-0008 |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 454096-0001 |
| Compressor Wheel OE | 431350-0017 |
| Ref | |
| Inducer Diameter(III) | 36.3 |
| Exducer Diameter(IV) | 52 |
| Tip Height(II) | 4.7 |
| Total Height(I) | - |
| Number of Blades | 8 |
| Flatback / Superback(Trim) | 50 |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 454096-0001 |
| Seal Plate & Back Plate OE | NA |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
