Language:
| Turbo Model | GT1646V (S3) |
| Vehicle OE No | 03G253010 |
| Model | Passat 2.0TDI 140PS |
| Engine | DPF PQ35/46 |
| ETP # | OE # | Ref # | |
| CHRA | 660125 in stock | NA | |
| Bearing Housing | 110131 in stock | NA | |
| Shaft & Wheel | 260114 in stock | NA | |
| Compressor Wheel | 280240 in stock | NA | |
| Back Plate | 360114 in stock | NA | |
| Heat Shield | 350107 in stock | NA | |
| Nozzle Ring Assembly | 370133 in stock | NA | |
| Turbine Housing | 220106 in stock | NA | |
| Compressor Cover | 240105 in stock | NA | |
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | - | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | 110131 |
| Turbo OE | 765261-0006 |
| Bearing Housing OE | NA |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | 260114 |
| Turbo OE | 765261-0006 |
| Shaft & Wheel OE | NA |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | 280240 |
| Turbo OE | 765261-0006 |
| Compressor Wheel OE | NA |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | 360114 |
| Turbo OE | 765261-0006 |
| Seal Plate & Back Plate OE | NA |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
