Language:
| Turbo Model | K14-2060GGB3.51GAAVB |
| Vehicle OE No | 35242028F |
| Model | Built-in engine |
| Engine | HR394HT |
| ETP # | OE # | Ref # | |
| CHRA | 5314-710-0501 | ||
| Bearing Housing | 5314-150-0036 | ||
| Shaft & Wheel | 5314-120-2111 | ||
| Compressor Wheel | 5314-123-2005 | ||
| Back Plate | 5314-151-5701 | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 5314-101-7002 | ||
| Compressor Cover | 5314-101-5008 | ||
| Actuator | 5806-110-0803 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -85,000rpm | ||
| T/hsg Angle | 190 | ||
| C/hsg Angle | 280 | ||
| Actuator Calibration 1 | Pressure 1.05 Bar = 2.1mm Rod Lift | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 5314-970-6002 |
| Bearing Housing OE | 5314-150-0036 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 5314-970-6002 |
| Shaft & Wheel OE | 5314-120-2111 |
| Ref | |
| Inducer Diameter(I) | 50 |
| Exducer Diameter(II) | 37.2 |
| Tip Height(III) | 6.2 |
| Journal Bearing Diameter(IV) | 8.470000000000001 |
| Comp Wheel Bore(V) | 5.4 |
| Number of Blades | 12 |
| Type Of Shaft | Straight |
| ETP No. | |
| Turbo OE | 5314-970-6002 |
| Compressor Wheel OE | 5314-123-2005 |
| Ref | |
| Inducer Diameter(III) | 30.1 |
| Exducer Diameter(IV) | 50 |
| Tip Height(II) | 4.6 |
| Total Height(I) | 25.8 |
| Number of Blades | 6 |
| Flatback / Superback(Trim) | 2060GGA |
| Shaft / Bore | 5.4 |
| ETP No. | |
| Turbo OE | 5314-970-6002 |
| Seal Plate & Back Plate OE | 5314-151-5701 |
| Ref | |
| Plate Diameter(III) | 51.5 |
| Plate Diameter(II) | - |
| Plate Diameter(I) | 108 |
| Plate Depth(IV) | 12.2 |
| Plate Diameter(V) | 14 |
| Flatback / Superback | flatback |
