Language:
| Turbo Model | GT1752H |
| Vehicle OE No | NA |
| Model | NA |
| Engine | NA |
| ETP # | OE # | Ref # | |
| CHRA | 433289-0010 | ||
| Bearing Housing | 435793-0005 | ||
| Shaft & Wheel | 434714-0009 | ||
| Compressor Wheel | 436131-0002 | ||
| Back Plate | 434689-0004 | ||
| Heat Shield | 434302-0001 | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 435788-0026 | ||
| Compressor Cover | 435791-0042 | ||
| Actuator | 433452-0002 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.0G Max 0 -90,000rpm / 1.5G Max 90,000 -138,000 | ||
| T/hsg Angle | 201 | ||
| C/hsg Angle | 281 | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 454061-0006 |
| Bearing Housing OE | 435793-0005 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 454061-0006 |
| Shaft & Wheel OE | 434714-0009 |
| Ref | |
| Inducer Diameter(I) | 44.2 |
| Exducer Diameter(II) | 37.5 |
| Tip Height(III) | 7.8 |
| Journal Bearing Diameter(IV) | 7.9 |
| Comp Wheel Bore(V) | 5.1 |
| Number of Blades | 9 |
| Type Of Shaft | Straight |
| ETP No. | |
| Turbo OE | 454061-0006 |
| Compressor Wheel OE | 436131-0002 |
| Ref | |
| Inducer Diameter(III) | 38.6 |
| Exducer Diameter(IV) | 52 |
| Tip Height(II) | 4.8 |
| Total Height(I) | 26.1 |
| Number of Blades | 6 |
| Flatback / Superback(Trim) | Superback |
| Shaft / Bore | 5.1 |
| ETP No. | |
| Turbo OE | 454061-0006 |
| Seal Plate & Back Plate OE | 434689-0004 |
| Ref | |
| Plate Diameter(III) | 53.00 |
| Plate Diameter(II) | 100.2 |
| Plate Diameter(I) | 129 |
| Plate Depth(IV) | 12 |
| Plate Diameter(V) | 10 |
| Flatback / Superback | Superback |
