Language:
| Turbo Model | K14-2070GGB4.82GBAVD |
| Vehicle OE No | 35242026A |
| Model | 33 |
| Engine | HR392HT |
| ETP # | OE # | Ref # | |
| CHRA | 5316-150-0037 | ||
| Bearing Housing | 5314-120-5002 | ||
| Shaft & Wheel | 5314-123-2002 | ||
| Compressor Wheel | 5314-151-5701 | ||
| Back Plate | NA | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | 5314-711-0012 | ||
| Turbine Housing | 5314-100-9005 | ||
| Compressor Cover | 5314-100-5003 | ||
| Actuator | 5810-110-4009 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -85,000rpm | ||
| T/hsg Angle | 117 | ||
| C/hsg Angle | 132 | ||
| Actuator Calibration 1 | Pressure 1.4 Bar = 1.95mm Rod Lift | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 5314-970-7002 |
| Bearing Housing OE | 5314-120-5002 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 5314-970-7002 |
| Shaft & Wheel OE | 5314-123-2002 |
| Ref | |
| Inducer Diameter(I) | 50 |
| Exducer Diameter(II) | 42 |
| Tip Height(III) | 5.9 |
| Journal Bearing Diameter(IV) | 8.5 |
| Comp Wheel Bore(V) | 5.4 |
| Number of Blades | 12 |
| Type Of Shaft | Straight |
| ETP No. | |
| Turbo OE | 5314-970-7002 |
| Compressor Wheel OE | 5314-151-5701 |
| Ref | |
| Inducer Diameter(III) | 35 |
| Exducer Diameter(IV) | 50 |
| Tip Height(II) | 4.6 |
| Total Height(I) | 25.8 |
| Number of Blades | 6 |
| Flatback / Superback(Trim) | 2070GGA |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 5314-970-7002 |
| Seal Plate & Back Plate OE | NA |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
