Language:
| Turbo Model | K14-2464GGA5.82GAAXD |
| Vehicle OE No | 500314776 |
| Model | Ducato 2.8 TD |
| Engine | 8140-43-2200 Euro 2 |
| ETP # | OE # | Ref # | |
| CHRA | 5314-710-0522 | ||
| Bearing Housing | 5316-150-0065 | ||
| Shaft & Wheel | 5314-120-5006 | ||
| Compressor Wheel | 5324-123-2010 | ||
| Back Plate | 5314-151-5702 | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 5314-100-9030 | ||
| Compressor Cover | 5324-100-5002 | ||
| Actuator | 5820-110-4123 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -85,000rpm | ||
| T/hsg Angle | 230 | ||
| C/hsg Angle | 262 | ||
| Actuator Calibration 1 | Pressure 1.4 Bar = 1.95mm Rod Lift | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 5314-970-6444 |
| Bearing Housing OE | 5316-150-0065 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 5314-970-6444 |
| Shaft & Wheel OE | 5314-120-5006 |
| Ref | |
| Inducer Diameter(I) | 50 |
| Exducer Diameter(II) | 42 |
| Tip Height(III) | 5.9 |
| Journal Bearing Diameter(IV) | 8.5 |
| Comp Wheel Bore(V) | 5.4 |
| Number of Blades | 12 |
| Type Of Shaft | Straight |
| ETP No. | |
| Turbo OE | 5314-970-6444 |
| Compressor Wheel OE | 5324-123-2010 |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 5314-970-6444 |
| Seal Plate & Back Plate OE | 5314-151-5702 |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
