Language:
| Turbo Model | GT2256V |
| Vehicle OE No | 79517 |
| Model | Ranger / Navistar -4 cyl. -2.8L |
| Engine | HS2.8 HT |
| ETP # | OE # | Ref # | |
| CHRA | 703891-0044 | ||
| Bearing Housing | 703881-0001 | ||
| Shaft & Wheel | 434882-0013 | ||
| Compressor Wheel | 702486-0010 | ||
| Back Plate | 703682-0057 | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | 720858-0001 | ||
| Turbine Housing | 716391-0008 | ||
| Compressor Cover | 702559-0013 | ||
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 0.65G Max 0 -90,000rpm / 2.00G Max 90,000 -168,0 | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 724652-0007 |
| Bearing Housing OE | 703881-0001 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 724652-0007 |
| Shaft & Wheel OE | 434882-0013 |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 724652-0007 |
| Compressor Wheel OE | 702486-0010 |
| Ref | |
| Inducer Diameter(III) | - |
| Exducer Diameter(IV) | - |
| Tip Height(II) | - |
| Total Height(I) | - |
| Number of Blades | |
| Flatback / Superback(Trim) | - |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 724652-0007 |
| Seal Plate & Back Plate OE | 703682-0057 |
| Ref | |
| Plate Diameter(III) | 57.50 |
| Plate Diameter(II) | 112 |
| Plate Diameter(I) | 129.1 |
| Plate Depth(IV) | 13.7 |
| Plate Diameter(V) | 10 |
| Flatback / Superback | Deep Superback |
