Language:
| Turbo Model | GT1746V Step 3 |
| Vehicle OE No | 4M5Q6K682AD |
| Model | Focus |
| Engine | Lynx Euro 4 |
| ETP # | OE # | Ref # | |
| CHRA | 660130 in stock | NA | |
| Bearing Housing | 110129 in stock | NA | |
| Shaft & Wheel | 260115 in stock | NA | |
| Compressor Wheel | 280241 in stock | 742678-0001 | |
| Back Plate | 360119 in stock | NA | |
| Heat Shield | 350107 in stock | NA | |
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | NA | ||
| Compressor Cover | NA | ||
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | - | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | 110129 |
| Turbo OE | 742110-0004 |
| Bearing Housing OE | NA |
| Ref | |
| VNT or Non-VNT | NON |
| Oil or Water Cooled | Cooled OIL |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | 106.3 |
| ETP No. | 260115 |
| Turbo OE | 742110-0004 |
| Shaft & Wheel OE | NA |
| Ref | |
| Inducer Diameter(I) | 39 |
| Exducer Diameter(II) | 33.2 |
| Tip Height(III) | 5.5 |
| Journal Bearing Diameter(IV) | 6.5 |
| Comp Wheel Bore(V) | 5.1 |
| Number of Blades | 11 |
| Type Of Shaft | Slender |
| ETP No. | 280241 |
| Turbo OE | 742110-0004 |
| Compressor Wheel OE | 742678-0001 |
| Ref | |
| Inducer Diameter(III) | 31.1 |
| Exducer Diameter(IV) | 44 |
| Tip Height(II) | 3.6 |
| Total Height(I) | 24.2 |
| Number of Blades | 6 |
| Flatback / Superback(Trim) | Deep Superback |
| Shaft / Bore | 5.1 |
| ETP No. | 360119 |
| Turbo OE | 742110-0004 |
| Seal Plate & Back Plate OE | NA |
| Ref | |
| Plate Diameter(III) | 45.00 |
| Plate Diameter(II) | 114.1 |
| Plate Diameter(I) | 117.4 |
| Plate Depth(IV) | 13.4 |
| Plate Diameter(V) | 10 |
| Flatback / Superback | Superback |
