Language:
| Turbo Model | GT25 |
| Vehicle OE No | 2674A224 |
| Model | 3 |
| Engine | T4.40 |
| ETP # | OE # | Ref # | |
| CHRA | 433289-0185 | ||
| Bearing Housing | 713782-0010 | ||
| Shaft & Wheel | 434717-0013 | ||
| Compressor Wheel | 436563-0003 | ||
| Back Plate | 721086-0001 | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 711739-0001 | ||
| Compressor Cover | 721260-0007 | ||
| Actuator | 436806-0023 | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -138,000rpm | ||
| T/hsg Angle | - | ||
| C/hsg Angle | - | ||
| Actuator Calibration 1 | - | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 711736-0024 |
| Bearing Housing OE | 713782-0010 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 711736-0024 |
| Shaft & Wheel OE | 434717-0013 |
| Ref | |
| Inducer Diameter(I) | - |
| Exducer Diameter(II) | - |
| Tip Height(III) | - |
| Journal Bearing Diameter(IV) | - |
| Comp Wheel Bore(V) | - |
| Number of Blades | |
| Type Of Shaft | - |
| ETP No. | |
| Turbo OE | 711736-0024 |
| Compressor Wheel OE | 436563-0003 |
| Ref | |
| Inducer Diameter(III) | 37.5 |
| Exducer Diameter(IV) | 56 |
| Tip Height(II) | 2.8 |
| Total Height(I) | - |
| Number of Blades | 6 |
| Flatback / Superback(Trim) | 45 |
| Shaft / Bore | - |
| ETP No. | |
| Turbo OE | 711736-0024 |
| Seal Plate & Back Plate OE | 721086-0001 |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | - |
| Plate Depth(IV) | - |
| Plate Diameter(V) | - |
| Flatback / Superback | - |
