Language:
| Turbo Model | TB2531 |
| Vehicle OE No | 9146010 |
| Model | 900/9.3 |
| Engine | B204 |
| ETP # | OE # | Ref # | |
| CHRA | 443854-0093 | ||
| Bearing Housing | 444360-0012 | ||
| Shaft & Wheel | 435257-0001 | ||
| Compressor Wheel | 446335-0010 | ||
| Back Plate | 430735-0001 | ||
| Heat Shield | NA | ||
| Nozzle Ring Assembly | NA | ||
| Turbine Housing | 413567-0034 | ||
| Compressor Cover | 409589-0342 | ||
| Actuator | NA | ||
| Repair Kit and Components | |||
| Calibration Data | |||
| VSR Balance Calibration | 1.5G Max 0 -85,000rpm | ||
| T/hsg Angle | 142 | ||
| C/hsg Angle | 79 | ||
| Actuator Calibration 1 | 0.300 -0.340 bar = 0.38 mm | ||
| Actuator Calibration 2 | - | ||
| Actuator Calibration 3 | - | ||
| ETP No. | |
| Turbo OE | 452068-0001 |
| Bearing Housing OE | 444360-0012 |
| Ref | |
| VNT or Non-VNT | - |
| Oil or Water Cooled | - |
| Oil Inter(II) | |
| Turbine Housing Diameter(I) | - |
| ETP No. | |
| Turbo OE | 452068-0001 |
| Shaft & Wheel OE | 435257-0001 |
| Ref | |
| Inducer Diameter(I) | 52.8 |
| Exducer Diameter(II) | 41.9 |
| Tip Height(III) | 6.3 |
| Journal Bearing Diameter(IV) | 9.2 |
| Comp Wheel Bore(V) | 6 |
| Number of Blades | 11 |
| Type Of Shaft | Straight |
| ETP No. | |
| Turbo OE | 452068-0001 |
| Compressor Wheel OE | 446335-0010 |
| Ref | |
| Inducer Diameter(III) | 42 |
| Exducer Diameter(IV) | 54 |
| Tip Height(II) | 5.9 |
| Total Height(I) | 24.7 |
| Number of Blades | 5 |
| Flatback / Superback(Trim) | Superback |
| Shaft / Bore | 6.0 |
| ETP No. | |
| Turbo OE | 452068-0001 |
| Seal Plate & Back Plate OE | 430735-0001 |
| Ref | |
| Plate Diameter(III) | - |
| Plate Diameter(II) | - |
| Plate Diameter(I) | 44.5 |
| Plate Depth(IV) | 6.7 |
| Plate Diameter(V) | 12.7 |
| Flatback / Superback | Superback |
